Canadian Salon Company

Canadian Salon Company

Electrical Installation – operating the Electric to the Cabinet Print

This instructional guide will help with the planning/installation associated with the Electrical Power provide for the Acrylic Spas.

Every one of our acrylic tubs have actually removable case panels which cover the whole border associated with bath tub.

Whenever running the electrical through the spa, the access point in to the cabinet doesn’t have become put appropriate during the Control Pack location. Our spas usually do not come loaded with a hole that is pre-drilled electric so access may be through some of the case panels.*

*NOTE: We do not advise installing the electric via a case panel that is situated in front a Pump, Control Pack, Blower, or Gate Valve. These panels will need to be likely eliminated sooner or later for maintenance or servicing.

Selecting an area

When selecting the best place to enter the case, do this in line with the after:

  • security (do not create hazards that are tripping
  • looks
  • access points for users to enter the bath tub
  • step positioning
  • cover opening position (bottom mount lifters need the address remainder low near the case)
  • address lifter mounts

Producing an Access Point

Since there are not any pre-drilled holes, access through the panel is completed employing a Hole Saw for a clear cut, a Spade Bit just isn’t suggested. The perfect location to place a gap for the power cord, is three to five ins up from the bottom associated with the case panel, and 3 to 4 inches in from the edge that is outside of case panel. Take note that the case panels have actually lumber insulating and framework foam inserts. Attempt to avoid drilling through the timber frame since this can damage the support that is structural timber provides.

We try not to suggest coming up through the bottom associated with the spa. Then we suggest you take into consideration that you will not be able to slide the tub in any way if this is the most ideal route.

This proceed tids site might pose issue if a site professional is needed to access a region of the bath tub that is against an obstruction such as for example a wall surface or deck.

The Control Pack (in which the electric will undoubtedly be linked) is likely to be found behind one of many cabinet panels straight below your Topside Control Panel (precise location shall vary based on spa model).

There was space that is enough the cabinet to perform the ability cable from the access point out the Control Pack even as we try not to entirely fill the cavity with spray foam. The energy cable will have to go into the Control Pack through the hand side that is left.

To find out more about connecting the electric to your circuit breaker, please click on our solution „Electrical Installation – Correct Wiring for a 240V Supply„.

In the event that you need any further help, be sure to contact client provider.

Arbeitsschritt

Kurzbeschreibung

Detaillierte Beschreibung

Transfer und Erfahrung

Medien

Schreibe einen Kommentar

Deine E-Mail-Adresse wird nicht veröffentlicht. Erforderliche Felder sind mit * markiert.